Table of Contents
Advertisement
The Information Menu is used for checking the status of the image signal being projected and the
operation of the projector.
Direct Operation
The information menu changes each time you
press the INFO. button on the remote controller
as follows.
page 1/2 page 2/2 hide page 1/2 • • • •
While the information menu is displayed, press
the Point ◄ ► buttons to display the previous or
next page.
Menu Operation
Press the Point ▲▼ buttons to select the
Information. The Information Menu is displayed.
See below for displayed information.
Input
The selected input source is displayed.
H-sync freq.
The horizontal frequency of the input signal is
displayed in KHz, or - - - - KHz when no signal.
V-sync freq.
The vertical frequency of the input signal is
displayed in Hz, or - - - - Hz when no signal.
Numbers of Hz doubles when during Interlace.
Screen
The selected Screen size is displayed.
Language
The selected language is displayed.
Lamp status
The selected lamp mode is displayed.
Lamp counter
The cumulative lamp operating time is displayed.
Power management
Shut down, Ready, Off Timer are displayed.
Key lock
The selected Key lock icon is displayed.
PIN code lock
Off or On 1 or On 2 is displayed.
Remote control
The selected remote code is displayed.
SERIAL NO.
The serial number of the projector is displayed.
The serial number is used to service the
projector.
Total power savings
The saved amount of power and the exhausted
CO2 are displayed.
Information
Input Source Information Display
Remote control
Information Menu
INFO. button
59
Advertisement
Table of Contents
