Figure 1-8 Exterior View (Vertical Installation) - Hitachi HF-W7500 Instruction Manual

(c) Vertical Installation
・When you install the equipment vertically, the status display lamps must come at the
upper side and make sure the equipment is placed so it does not fall.
・When you mount the equipment vertically, prepare a mounting metal fitting as shown in the
figure below and use it to secure the equipment.
・The mounting metal fitting for vertical installation must be secured to a mounting chassis or
rack with casters using set screws at both the upper and lower positions.
・For information about how to remove rubber feet, see "6.3.9 Attaching and removing
rubber feet".
The bottom of the equipment
74.5mm
Front side
When you install the equipment on the vertical installation bracket, do not use the
cover screws to secure the equipment. If you use the cover screws, the equipment
may fall and personal injury may result.
150mm or more
301mm
367mm

Figure 1-8 Exterior View (Vertical Installation)

Mounting Metal Fitting for Vertical Installation
Use a steel plate.
The thickness must be 3mm or more.
Four M4 (acceptable depth is 8 mm or less)
CAUTION
1-18
1. GETTING STARTED
Four M4 screws