Table of Contents
Advertisement
1.6.2 Installation
The power cord that comes with the equipment is rated at the input voltage of
125 VAC. When using this equipment at over 125 VAC, prepare the power cord
fitting input voltage and inspect the safeness of this equipment enough.
When you connect the plug of the power cord to an outlet, make sure you use
an outlet with a ground terminal (ground pole) that is properly grounded. In
addition, you must install and use an earth leakage circuit breaker.
If you do not take these measures, that may result in a fire or an electric shock.
Do not use a two-prong plug without a ground pole because that may result in
an electric shock or failure of the equipment.
When you install the equipment vertically, be sure to secure it with a vertical
installation bracket. If you do not secure it with the installation bracket, the
equipment may fall and personal injury may result.
Before you move this equipment, make sure you shut down the OS, disconnect
the plug of the power cord from the outlet, and wait for at least one minute.
If you do not, the HDDs and other devices may fail.
When you transport or carry the equipment, pack it in the dedicated container
(container and packing materials used when the equipment was delivered). If
you use other container or packing materials, that may damage the equipment.
Do not use damaged or broken dedicated container when you transport or
carry the equipment. If you do, that may damage the equipment.
< NOTE >
・For information about the precautions for concerning installation requirements,
see "PRECAUTIONS 1. PRECAUTIONS ABOUT THE EQUIPMENT (5)
INSTALLATION ENVIRONMENT".
WARNING
CAUTION
NOTICE
1-14
1. GETTING STARTED
Advertisement
Table of Contents
