Table of Contents
Advertisement
SAFETY INSTRUCTIONS (Continued)
When RAID 1 is newly configured, RAID 1 configuration information
corresponding to only one equipment being used is recorded on the HDD.
The HDD with configuration information recorded can not be used with other
equipment, so users who use multiple equipment, should be careful not to handle
and store HDDs to not to mix.
If HDDs are mixed, the RAID 1 configuration information may be inconsistent,
the equipment may not operate normally, or the data in the HDD may be lost.
When you build a RAID1 system from scratch, prepare two new HDDs selected
from the models specified and tested by HITACHI. Otherwise, the data stored on
the HDDs may be lost.
Never remove an HDD when the HDD status lamp of the HDD is OFF.
If you do, the data stored in the HDD gets corrupted.
Wear cotton gloves when replacing an HDD in order to prevent problems
caused by static electricity. If you do not, the data stored on the HDD may
get corrupted.
Make sure you check the correct procedure before you start the work.
If you do not follow the correct procedure, the data stored on the HDD may
be lost.
As a replacement HDD, do not use an HDD previously used. If you do, this
equipment may not operate properly or the data on the HDDs may be lost because
of configuration information mismatches or other reasons.
Mount an HDD securely. Loose contact and missing screws may result in a failure.
Do not subject an HDD you are mounting and the already mounted HDDs to shock
while replacing an HDD. Otherwise, failure of the drive may result.
Until the rebuild is complete, avoid shutting off the power for this equipment or
attaching and detaching HDDs. Otherwise, the data on the HDDs may be lost or
a failure may result.
S-17
(Page 10-3)
(Page 10-7)
Advertisement
Table of Contents
