10. RAID1
6. Mount the replacement HDD on the computer.
(See "6.3.6 Installing and removing an HDD".)
The HDD status lamp blinks after a while and RAID1 rebuilding starts.
The RAID1 rebuilding takes about 6 hours. (HDD without load)
<Notice>
• If rebuilding does not start with the HDD status lamp lit after about a minute,
remove the HDD and re-execute from the procedure 5.
• After the HDD has been mounted on the equipment, the drive bay status is
shown on the hardware status display window until rebuilding is completed.
If it is not displayed, click the Refresh button.
Hardware status display window (Rebuilding in progress)
10-10