Table of Contents
Advertisement
Booster Installation
Before Installation
Before installation, make note of these important factors:
• A "soft install" is recommended for each section of your installation before
permanent placement of parts.
• The booster will need to be close enough to an existing electrical outlet.
• A minimum of 50 ft. of separation between the outdoor antenna and indoor antennas is
recommended.
• There will need to be sufficient cable length between planned outdoor antenna location and
booster connector.
• There will need to be sufficient cable length between planned indoor antenna location and
booster connector. Additional cable may be purchased if needed.
Installation Overview
1. Find the outside area that has the strongest signal. (See page 7).
2. Install the outdoor antenna in the area identified in step 1. (See page 8).
3. Install the indoor antennas where increased signal is needed. (See page 11).
4. Mount the signal booster, connect the outdoor and indoor antenna cables to the signal
booster, and connect the booster to an AC power source. (See page 16).
FCC 27.5 (d)(4) Statement: Fixed, mobile, and portable (hand-held) stations operating in the 1710-1755 MHz band
as well as mobile and portable stations operating in the 1695-1710 MHz and 1755-1780 MHz bands are limited to
1 watt EIRP. Fixed stations operating in the 1710-1755 MHz band are limited to a maximum antenna height of 10
meters above ground. Mobile and portable stations operating in these bands must employ a means for limiting
power to the minimum necessary for successful communications.
6
SureCall | 1-888-365-6283 | support@surecall.com | www.surecall.com
Advertisement
Table of Contents
Need help?
Do you have a question about the SC-PolyO2-72 and is the answer not in the manual?
Questions and answers