SureCall SC-PolyO2-72 User Manual page 12

Installation
For Each Antenna:
1. Drill a 20 mm diameter hole in the ceiling. The ceiling thickness should be 20 mm,
maximum.
2. Unscrew fixing nut from antenna. Place antenna cable through hole. Screw the fixing nut
back onto antenna and cable on crawl space side of ceiling and fasten.
3. Tighten fixing nut to secure antenna (do not over-tighten).
For kits with a single indoor antenna:
4. Connect female antenna connector to a the indoor antenna cable provided with your kit
and run along route toward the planned location of your booster.
For kits with multiple indoor antennas:
4. Connect each indoor antenna to a the indoor antenna cable provided with your kit and run
along route toward the planned location of your booster. Join all cables to provided cable
splitter.
5. Connect one end of the provided cable to the remaining port of the cable splitter labeled
INPUT and route cable to the planned location of your booster.
Note: Be sure to provide enough separation from outdoor antenna (at least 50 ft. is
recommended).
Storage and transportation: Store and place in non-extreme room-temperature and dry
Important:
environment This antenna should not be used near open fire or flame.
Outdoor Antenna
Outdoor
Cable
12
SureCall | 1-888-365-6283 | support@surecall.com | www.surecall.com
4-Way Splitter
Indoor Antenna
Splitter
Cable
Planned
booster
location
Indoor
Cables
Indoor Antenna
Splitter + 30 ft cable
(for multiple antenna
kits)