multicomp pro MP700506 User Manual page 76

3) [Line Low On Off]
When the lower limit line is turned on or off, the lower limit line is
opened by default when the area measurement is on.
4) [Shift X/Y Freq Ampt]
Frequency: For the actual measurement, the edited area as a
whole superimposed on a frequency, so that it can implement left
or right shift, easy to measure. Does not affect the frequency and
marker of the spectrum analyzer settings.
Amplitude: The region has been edited on the whole
superimposed on a degree, so that it can move up or down, easy
to measure. Does not affect the amplitude setting of the spectrum
analyzer.
5) [UpLine Edit ►]
Upper line editing is used to edit the control line above the trace,
depending on the trace.
6) [LowLine Edit ►]
Lower line editing is used to edit the control line above the trace,
depending on the trace.
5.16.7【Meas Setup ►】
Measurement setting menu for the corresponding measurement
parameter settings when adjacent channel power, channel power,
occupied bandwidth measurement mode is turned on.
5.16.7.1 [Channel BW]
Set the bandwidth of the channel power measurement, and set the
72