Table of Contents
Advertisement
The sixth chapter
Examples of application
6.1 Simple signal measurement
An unknown signal observation circuit, rapid display and measure the signal frequency and
amplitude.
● To quickly display the signal, please click the following steps:
（1）Set probe menu attenuation coefficient to 10 x, and set the switch on the probe to 10 x,
connect the probe to the oscilloscope channel 1 (CH1).
（2）Long press "PRW" button, then press "F1" to enter the oscilloscope (or if the oscilloscope
in other functional interface, press "MENU" -> "F1").
（3）Will probe received corresponding clamp circuit, CH1 probe were connected to the circuit.
（4）Press the "AUTO" button.
Digital storage oscilloscope is automatically set to waveform shows best. Based on this, you
can further adjust the vertical and horizontal gear of waveform, until the waveform display
meet your requirements.
● For automatic measurement signal voltage and time parameter
Digital storage oscilloscope can be automatic measurement for most display signal, to measure
the signal frequency and peak value, please click the following steps:
64
Advertisement
Table of Contents
