Table of Contents
Advertisement
5.2 A serial port center operations
● First enter the oscilloscope interface: hold down the "PRW" button, enter the boot interface
according to the "F1" button to enter the oscilloscope operating interface, and then press
"CH2" -> "F3" will gear is set to 1 x. (this step is very important)
●
To probe the gears is set to 1 x.
●
Into the heart of the serial interface: long press "MENU" -> "F3". Menu interface is as
follows:
A serial port center menu page（page1/2）
A serial port center menu page（page2/2）
60
Advertisement
Table of Contents
