Table of Contents
Advertisement
Press the "CH1"→"F4" select Settings to communicate. Only allow ac component, dc component
is filter. Waveform display as shown in figure 2-4.
● Press the "CH1"→"F4" option set to dc. Ac and dc component were allowed through. Waveform
display as shown in figure 2-5.
Figure 2-4 coupled dc
Figure 2-5 coupled ac
2.Probe the proportion set
In order to coordinate the attenuation coefficient of the probe, needs to adjust the
corresponding probe in the channel operation menu attenuation ratio. If attenuation coefficient
for X10 probe, oscilloscope probe proportion of input channels should be set to 10 x, to ensure
32
Advertisement
Table of Contents
