Table of Contents
Advertisement
of holographic. The specific steps are as follows:
(1) the oscilloscope after equipped with batteries, long press the oscilloscope in the top
right corner of the red "PRW"
Key, until I heard a buzzer sound can let go, oscilloscope into at this time
Boot screen, as shown in figure 1-6
(2) enter the boot screen, can choose instrument by selecting the button F1 ~ F5
Mode, the default is selected "oscilloscope", selected after about 3 s or so
Automatically entered into the oscilloscope operating interface.
(3) will probe from the oscilloscope channel 1 (CH1) and probe to 10 x gear, pull it
After grounding clip to receive the signal
(4) press the "CH1", then press "F3" will probe set to 10 x
(5) will probe needle comes into contact with the need to test signal source, press the "AUTO"
button,
At this point, the oscilloscope is automatically set vertical, horizontal and trigger system,
and will be
Waveform display the best effect of the signal.
25
Advertisement
Table of Contents
