Jinhan JDS3022E Manual page 38

Table 2-3 edge-triggered menu function table
source CH1
CH2
slope rising
falling
automatic
triggered
normal
single
Instructions:
Set the source:
1, press "TRIG" display trigger menu, according to the signal input, press "F1" choose "CH1" or
"CH2".
Set the trigger level
2, press the "CH1" button, then press "
Set the CH1 to source trigger signal
Set the CH2 to source trigger signal
Select trigger signal is rising along the trigger
Choose falling edge trigger signal in the trigger
Set up under the condition of no detected trigger can also
collect waveform
Set up only when the trigger condition collecting waveform
Set when detected a trigger to collect a waveform, then stop
" button to adjust the lower left panel channel 1
38