Table of Contents
Advertisement
（ 1 ） Open the master computer "serial" serial debugging tools, such as set the baud rate to
9600, 8 bits, check the NO, 1 stop bit to send data base "11 22". As shown in figure 5-3
(2) is set to the same as (1) at the center of the serial port Settings, by F1 ~ F5 to select
a menu item, and then by pressing the "
" or"
" ，selected set parameters, finally press
the" OK "key.
（3）Open the computer serial port, and set to cycle to send (here to send a set to 1000 ms),
press "F1" key to open the serial port serial center
At this point from the display window can observe the hexadecimal computer serial port to send
data "11 22". As shown in figure 5-4
62
Advertisement
Table of Contents
