Timeout Between Decodes (Same Barcode) - Newland HR3260-CS User Manual

【Enter Setup】

Timeout between Decodes (Same Barcode)

Timeout between Decodes (Same Barcode) can avoid undesired rereading of same barcode in a given
period of time.
To enable/disable the Timeout between Decodes (Same Barcode), scan the appropriate barcode below.
Enable Timeout between Decodes: Do not allow the scanner to re-read same barcode before the
timeout between decodes (same barcode) expires.
Disable Timeout between Decodes: Allow the scanner to re-read same barcode.
**【Disable Timeout between Decodes】
The following parameter sets the timeout between decodes for same barcode. It is programmable in 1ms
increments from 0ms to 65,535ms. The default setting is 1,500ms.
Set the Timeout between Decodes (Same Barcode) to 2,500ms:
1. Scan the Enter Setup barcode.
2. Scan the Timeout between Decodes (Same Barcode) barcode.
3. Scan the numeric barcodes "2", "5", "0" and "0". (See the Digit Barcodes in
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Exit Setup barcode.
**【Exit Setup】
【Timeout between Decodes (Same Barcode) 】
Appendix)
【Enable Timeout between Decodes】
28