Table of Contents
Advertisement
【Enter Setup】
Set Length Range for Standard 25
The scanner can be configured to only decode Standard 25 barcodes with lengths that fall between
(inclusive) the minimum and maximum lengths. To accomplish it, you need to set the minimum and
maximum lengths.
【Set the Minimum Length (Default: 6)】
Maximum length of a 1D barcode should not exceed 127 bytes. If minimum length is
set to be greater than maximum length, the scanner only decodes Standard 25
barcodes with either the minimum or maximum length. If minimum length is same as
maximum length, only Standard 25 barcodes with that length are to be decoded.
Set the scanner to decode Standard 25 barcodes containing between 8 and 12
characters:
1. Scan the Enter Setup barcode.
2. Scan the Set the Minimum Length barcode.
3. Scan the numeric barcode "8". (See the Digit Barcodes in Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes in Appendix)
5. Scan the Set the Maximum Length barcode.
6. Scan the numeric barcode "1".
7. Scan the numeric barcode "2".
8. Scan the Save barcode.
9. Scan the Exit Setup barcode.
**【Exit Setup】
【Set the Maximum Length (Default: 127)】
106
Advertisement
Table of Contents
