Site Preparation Guide
Environmental Requirements
•
The F123 Series printer is for indoor use only.
•
Air quality conditions with excessive solid particulates (conductive or non-conductive) may
result in system damage.
•
Air quality conditions in which airborne oils are allowed to accumulate on or within the
printer can damage the plastic components.
•
System operating temperature shall be in the range of 59°F to 86°F (15°C to 30°C), with
relative humidity range of 30% to 70% non-condensing.
•
System storage temperature shall be in the range of 32°F to 95°F (0°C to 35°C), with
relative humidity range of 20% to 90% non-condensing.
•
Altitude shall not exceed 6561.68 feet (2000 m).
•
Material storage shall be in the range of 55°F to 86°F (13°C to 30°C), with relative humidity
less than 70%.
•
Noise emission (acoustic): <32dBA when idle, <46dBA when building
Heat Output
Heat dissipation occurs mostly through the top of the printer. Heat output is material dependent
due to the various temperatures maintained in the build chamber.
ABS
ABS ESD7
ABS-CF10
PC-ABS
PLA
ASA
TPU 92A
Diran
Nylon-CF10
Material Type
Heat Output (while building)
~2300 BTU/hr
~2300 BTU/hr
~2600 BTU/hr
~2600 BTU/hr
~550 BTU/hr
~2300 BTU/hr
~2300 BTU/hr
410MF07 ~2950 BTU/hr
TM
~2600 BTU/hr
Site Requirements
Heat Output (while idle)
~1800 BTU/hr
~1800 BTU/hr
~2200 BTU/hr
~2100 BTU/hr
~35 BTU/hr
~1800 BTU/hr
~1800 BTU/hr
~2900 BTU/hr
~2200 BTU/hr
Page 7