Site Preparation Guide
Remove Shipping Materials
1. Inspect the Tilt Indicators (2) and ShockWatch indicator affixed to the exterior of the
cardboard box. If possible, take a picture of these indicators to share with your installation
representative. If damage is detected upon installation, this photo will assist your
installation representative in determining the cause of damage
2. Using a Phillips screwdriver, remove the cover mount screws from the base of the crate
(Figure
3. Carefully cut the shipping bands
4. Remove the cardboard cover from the top of the crate
5. Remove the 2 protective cardboard container panels encasing the printer
4).
Rear View
Warning: Personal Injury Hazard
Shipping bands are very tight; when cutting shipping bands they may pop open with
force. Wear safety glasses when removing the shipping bands.
Figure 4: Shipping Crate Detail
Tilt
Indicator
(2 as shown)
Shipping
Bands (6)
Cover Mount
Screws
(Figure
4).
Preparing for Installation
(Figure
4).
Front View
ShockWatch Indicator
(1 as shown)
(Figure
5).
(Figure
5).
Page 11