Stratasys F123 Series Site Preparation Manual page 20

Site Preparation Guide
4. Remove all tape and carefully unwrap the printer by pulling the plastic bag downward.
5. Using a utility knife cut, away and remove the plastic bag's material. Ensure that the bag is
not blocking the exit side of the ramp or the printer's wheels so that the printer can roll
freely down the ramp.
6. Make sure that all four stabilizing pads are in the highest possible position.
7. Carefully roll the printer from the shipping base using the ramp.
8. Inspect the printer's exterior for dents and scratches. Immediately report any damage to
Stratasys and the shipping company.
9. Roll the printer into its approximate operating location.
10. Open the oven door, cut the cable tie securing the startup materials, and remove the
startup materials from the oven chamber.
11. Open the top cover. Cut the zip ties securing the head and X bridge to the front left corner
of the gantry. Confirm that the toggle plate moves smoothly throughout the gantry.
12. Open the chamber door and remove the orange tape securing the tip wipe assemblies to
the purge chute.
When removing the printer it is recommended that one person guide each side of
the printer.
Position the printer to allow at least three feet of clearance on all sides until the
installation process is complete, see
Requirements" (page 4).
setup instructions.
"Physical Specifications and Space
Refer to Chapter 2 of the F123 Series User Guide for final
Preparing for Installation
Page 16