Site Prep Tasks; Selecting The Site; Space Requirements; Uncrated Dimensions And Weights - Stratasys Dimension Elite / 768 Site Preparation Manual

SITE PREP TASKS

SELECTING THE SITE

Decide where to install the printer based on the following:

1. Space Requirements

2. Workstation Requirements

3. Environmental Requirements

4. Electrical Requirements
5. LAN Requirements
SPACE REQUIREMENTS

UNCRATED DIMENSIONS AND WEIGHTS

Make sure that the installation location can accommodate the printer's weight and dimensions, plus required
clearances. The installation location must be a stable flat surface capable of holding 300 pounds (136 kg).
Height
Width
Depth
Weight

MINIMUM CLEARANCES

Sufficient rear and side clearances allow for proper air circulation, while sufficient front clearance allows enough
room for the oven door to be opened.
Side Clearance
Rear Clearance
Front Clearance
ENVIRONMENTAL REQUIREMENTS
• The Dimension Elite/768 printer is for indoor use only.
• Air quality conditions with excessive solid particulates (conductive or non-conductive) may
result in system damage.
• Air quality conditions in which airborne oils are allowed to accumulate on or within the printer
can damage the plastic components.
• Operating temperature shall be in the range of 59°F to 86°F (15°C to 30°C), with relative
humidity range of 30% to 70% non-condensing.
Storage temperature shall be in the range of -40°F to 129.2°F (-40°C to 54°C), with relative
•
humidity range of 10% to 85% non-condensing.
• Altitude shall not exceed 6561.68 feet (2000 m).
• Typical heat emission shall be 1080 Watts = 3686 BTU/hour, and maximum heat emission shall
be 1380 Watts = 4710 BTU/hour.
41 inches (104.1cm)
27 inches (68.6 cm)
36 inches (91.4 cm)
282 pounds (127 kg)
Minimum 6 inches (15.2 cm) on each side
Minimum 4.5 inches (11.4 cm)
Minimum 17 inches (43.2 cm)
2