Wlan Leds; Dip Switches; Ground Pins - Avnet MSC C10-MB-EV User Manual

MSC C10-MB-EV

4.25 WLAN LEDs

There are three yellow LEDs placed near PCIe Mini Card slot. They indicate the card type.

Wireless Wide Area Network (WWAN).

Wireless Local Area Network (WLAN).

Wireless Personal Area Network (WPAN).

4.26 DIP Switches

There is an array of DIP switches at the card edge to configure various functions.

References:

Type:

Location: Card edge
Reference No. Function
S2804 4
S2804 3
S2804 2
S2804 1
S2805 4
S2805 3
S2805 2
S2805 1
S2802 4
S2802 3
S2802 2
S2802 1
S2801 4
S2801 3
S2801 2
S2801 1
S2803 4
S2803 3
S2803 2
S2803 1

4.27 Ground Pins

There are several ground pins spread over the base board for connection of measurement
equipment.
S2801, S2802, S2803, S2804, S2805.
4pol
LCD EPROM ENA (default on)
BCKL ENA POL
LCD ENA POL
LID#
GPIN 3
GPIN 2
GPIN 1
GPIN 0
PEG_SEL#
eDP#/LVDS Select
BIOS DIS 0 (default off)
BIOS DIS 1 (default off)
PSON S5#
PSON S4#
PSON S3# (default on)
AT MODE
SIO ENA / OFF = DIS
SIO CFG ADR 4E=ON/2E=OFF
SIO KBD ENA
SIO 48MHz=ON/24MHz=OFF
Table 28 DIP Switch Overview
47 / 48
Description
Off enables carrier EDID EEPROM
Backlight polarity, off = low active
LVDS enable polarity, off = low active
On = 680R to GND
On = GND
On = GND
On = GND
On = GND
No function
eDP / LVDS selection (on = eDP)
BIOS selection table at chapter 4.17
BIOS selection table at chapter 4.17
Selects source for PSON signal.
Selects source for PSON signal.
Selects source for PSON signal.
ATX always on (PSON is set to GND)
On enables SIO W83627
SIO address selection (default off, 2E)
SIO keyboard controller enable (on)
SIO PEN48 (default on, 48MHz)
User Manual