MSC C10-MB-EV
User Manual
4.7
LVDS Interface
Any LVDS display can be connected via a JILI30 connector.
One 24 bit LVDS channel is present on this 30-pin connector.
The signals of the LVDS interface are shared with the eDP port. To use the signals for the
LVDS S2802 #3 has to be set open.
The supply voltage of the display can be adjusted with jumper JP1101. The according
position is printed on the PCB.
If the display needs a low active start signal VDD_EN, DIP-Switch S2804 #2 has to be set
open.
If the display needs a high active start signal VDD_EN, DIP-Switch S2804 #2 has to be set
on.
23 / 48