Usb Client Connector; Ethernet - Avnet MSC C10-MB-EV User Manual

MSC C10-MB-EV

4.10.3 USB Client Connector

The USB Port 7 signals were switched to a 5 pin header, if a USB client is plugged at
X1903.
Specification:

References:

Connector:

Pin-out: Refer to Table 14

Location: Refer to chapter 4.10 USB Topology
Pin Signal
1 VCC_IN_CLIENT
2 USB_P7_N
3 USB_P7_P
4 GND
5 GND_SHLD

4.11 Ethernet

The base board can be connected to a local area network with an Ethernet interface. The
COM Express module already provides MDI signals, so that only the transformer on the
base board required. The transformer is integrated in X702.
Specification:

References:

Connector:

Pin-out: Refer to IEEE Std. 802.3
[9, section three, page 225]

Location: Refer to chapter 4.10 USB Topology
Color Status
Yellow Off
Yellow Blinking
Green/Orange Off
Green On
Orange On
X1903
single row pin header
Function
Power in
USB port 7 negative signal
USB port 7 positive signal
Power Ground
Ground Shield
Table 14 USB Client Connector
X702
Würth 749110616 (RJ45LAN 10/100/1000 BaseT + USB 3.0)
Description
No link
Link established, activity detected
10 Mbps
100 Mbps
1000 Mbps
Table 15 LAN LED Description
33 / 48
User Manual