Table of Contents
Advertisement
OPERATION
Figure Ops-1014 shows a FX-315 cutter set-up with clockwise blade rotation on the center section and right
wing, and counter clockwise blade rotation on the left wing.
Examples:
If there is material buildup in sections B + E, raise shrouds 1 + 5 to allow some material out sooner.
If more material is found in sections A + B and less in C + D, then shroud 2 can be lowered to allow less
material from the center section.
If a lot of material is found in sections A + F, then lower the rear end of shrouds 1 + 5 to bring more material
around towards the center.
FX-315/FX-310 03/21
Operation Section 4-17
© 2021 Alamo Group Inc.
Advertisement
Table of Contents
