PRO LEVEL CLEVIS
The pro level clevis is designed to fit CAT II and CAT III drawbars.
The clevis comes with two factory installed CAT II
conversion adapters, shown in grey to the right. To
convert to CAT III remove the 1/2" x 1" UNC bolts,
top and bottom, then remove adapters.
NOTE: Connect clevis to drawbar in orientation as
shown to the right and as indicated by decals on
clevis. Connecting in any other orientation will result
in serious damage to the Clevis, hitch and/or
drawbar.
PRECISION CLEVIS
Adjust the opening of the precision clevis by
shimming the wear plate with the spacers. Remove
the two 5/8" bolts and lockwashers and stack the
spacers between the wear plate and the hitch block
until the opening measures less than 1/8" taller than
the drawbar. Replace unused spacers under the
hitch block and reinstall the lockwashers and bolts.
NEVER USE YOUR HANDS TO STEADY THE HITCH BLOCK WHILE THE TRACTOR IS
BEING BACKED TO THE HITCH
NEVER STAND BETWEEN THE TRACTOR AND THE ROTARY CUTTER WHILE THE
TRACTOR IS BEING BACKED TO THE HITCH
FX-315/FX-310 03/21
© 2021 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-6