Tightening Instructions For 517 & 511 Hubs; Tires - Schulte FX-315 Operator's Manual

Tightening Instructions for 517 & 511 Hubs
Proper setting for the tapered roller bearings is described in the following procedure. Always use a new cotter
pin when making adjustments to the hubs.
1. Tighten the castle nut to 20 foot pounds while turning hub. Then back the nut off 1/2 of a turn. Spin the hub
2 or 3 times. While slowly turning hub clockwise, finger tighten the castle nut until castle nut notch lines up
with hole in axle. If notch will not line up, back off nut to next notch.
2. Put the cotter pin in the axle hole. Before bending the cotter pin, spin the hub. The hub should free wheel
from 1 to 2 full turns.
3. If the hub spins the right amount, finish installing the cotter pin by bending the ends.
4. Coat the inside of the dust cap with a thin coat of grease by using your finger. Then install on hub using the
right dust cap driver.
5. Wipe off all excess grease from hub and axle.
There should not be any drag noticed when spinning a tire installed on a hub. If the axle nut
is too tight, the rollers of the wheel bearings will remove the grease from the bearing races,
decreasing the life of the bearings.

Tires

Periodically check tire pressure. Aircraft tires should be inflated to 42 PSI.
To remove tires for repair or replacement, install the center transport lock pin. Relieve hydraulic pressure Shut
off tractor, apply parking brake and disengage PTO. Loosen the wheel bolts with wrench. DO NOT remove
them. Use a hydraulic jack to lift the back end of the cutter frame near the wheel standard. Securely block the
wheel standard so the tire can spin freely before removing the wheel bolts.
AVOID PERSONAL INJURY. DO NOT work under cutter without support blocks to keep the
frame from falling.
TIRE
ASSEMBLY
210-003 Solid Laminated Tire, 20
210-175 Forklift Tire
210-175F Forklift Tire, Foam Filled
210-192 Solid Laminated Tire, 26
210-540 Severe Duty
210540F Severe Duty, Foam Filled
FX-315/FX-310 03/21
© 2021 Alamo Group Inc.
MAINTENANCE
Tire Speed / Inflation Pressure:
DESCRIPTION
Maintenance Section 5-17
TRANSPORT
SPEED
20 kph or 12 mph n/a
40 kph or 25 mph 90 PSI / 6.2bar / 620 KpA
40 kph or 25 mph n/a
20 kph or 12 mph n/a
40 kph or 25 mph 40 PSI / 2.8 bar / 280 KpA
40 kph or 25 mph n/a
INFLATION
PRESSURE