Schulte FX-315 Operator's Manual page 75

OPERATION
The cut height for the center section is set by
extending or shortening the depth collar located on
the center lift cylinder. Cutting height for the wing
cylinders will be automatically controlled by the
hydraulic phasing system. Only the center section
cylinder should be used for adjustment.
If depth control stops are not set at the same height as the center cylinder, internal damage
may occur to the phasing cylinders.
The cutter should always be operated in the highest position that will produce the desired cutting results.
Operating at increased heights will minimize the chances of blades contacting the ground and discharging
debris.
1. Place the tractor and cutter on a level surface and lower wing sections.
2. Extend or retract the center section main hydraulic lift cylinder to the desired cutting height.
3. Shut down the tractor, place the transmission in park, and set the parking brake before dismounting.
4. Set the depth stop adjustment on the center cylinder so that the cylinder returns to the preset cutting height
each time the cutter is lowered.
FX-315/FX-310 03/21 Operation Section 4-13
© 2021 Alamo Group Inc.