Care And Maintenance; Adjusting The Running Mat - CARDIOSTRONG TX70 Assembly And Operating Instructions Manual

For more information, please visit cardiostrong.com, sport-tiedje.com
Table of Contents

Advertisement

5.4

Care and Maintenance

The most important maintenance measure is the care of the running mat. This includes adjustment,
re tensioning and lubrication of the running mat. Damage resulting from insufficient or neglected
care is not covered by the warranty. You should therefore carry out maintenance checks at regular
intervals. Be very careful when adjusting and tightening the running mat, as a strong over voltage
or under voltage can cause damage to the equipment. The running mat is adjusted at the factory
according to the regulations before delivery. However, it may happen that the running mat slips
during transport.
By scanning the QR code with the camera function or QR code scanner app of
your smartphone/tablet, a video on general maintenance of a treadmill opens on
YouTube. The video serves to illustrate the maintenance points described in this
manual.
Please note that the video may not be available in your language or with appropriate
subtitles.
If you cannot scan QR codes, you can access all Sport-Tiedje videos on YouTube by first opening
YouTube and entering "Sport-Tiedje" in the search field.
5.4.1

Adjusting the Running Mat

During training, the running mat should
run as centrally and straight as possible.
The alignment of the running mat can
change depending on the stress and load.
Another reason can be the positioning of the
equipment on an uneven surface.
CAUTION
During
the
following
nobody must be on the treadmill!
1.
Let the treadmill run at a speed of 5 km/h.
2.
If the running mat deviates to the left,
turn the left adjusting screw at the
rear end of the device max. one ¼ turn
clockwise and the right adjusting screw
max. one ¼ turn anticlockwise.
3.
If the running mat deviates to the right, turn the right adjusting screw at the rear end of the
device max. ¼ turn clockwise and the left adjusting screw max. ¼ turn anticlockwise.
4.
Then observe the mat for about 30 seconds, as the change is not immediately visible.
5.
Repeat this procedure until the running mat is straight again. If the running mat cannot be
adjusted, please contact your contract partner.
maintenance
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cst-tx70

Table of Contents