CARDIOSTRONG TX70 Assembly And Operating Instructions Manual page 21

Step 9: Alignment of the Feet
If the floor is uneven, you can stabilize the treadmill by turning the two setting screws under the
main frame.
⚠ WARNING
The treadmill is equipped with high-pressure shock absorbers that can cause the treadmill
to suddenly open if handled incorrectly. For more information, refer to the section 2.1 of this
manual.
1. Lift the treadmill on the desired side and rotate
the setting screws under the main frame.
2. Rotate the screws clockwise in order to remove
them and to raise the running surface.
3. Rotate them counterclockwise in order to lower
the running surface.
Step 10: Connecting the Equipment to the Mains Supply
࣑ ATTENTION
The equipment must not be connected to a multiple socket, otherwise it cannot be guaranteed
that the equipment will be supplied with sufficient power. Technical errors can result.
Plug the power plug into a wall outlet that complies with the instructions in the chapter on electrical
safety.
Down
Up
21