Table of Contents
Advertisement
installation
CLEARANCES
The clearances listed below are Minimum distances unless otherwise stated:
A major cause of chimney related fires is failure to maintain required clearances (air space) to combustible materials. It is of the greatest importance
that this fireplace and vent system be installed only in accordance with these instructions.
Caution Requirements
The top, back and sides of the fireplace are defined by
standoffs. The metal ends of the standoff may NOT be
recessed into combustible construction.
Clearance:
A: Mantel Height (min.)
B: Sidewall (on one side)
C: Ceiling
(room and/or alcove)
D: Mantel Depth (max.)
E: Alcove Width
F: Alcove Depth
G: From Floor
Note:
NOTE: The unit can be installed onto a combustible base.
D
A
G
8
Dimension
Measured From:
438mm
Top of Fireplace Opening
146mm
Side of Fireplace Opening
1003mm
Top of Fireplace Opening
305mm
667mm Above Fireplace Opening
1480mm
Sidewall to Sidewall (Minimum)
787mm
Front to Back Wall (Maximum)
610mm
Top of Fireplace Opening
0
F
B
E
Installed Close
to Floor
F
if these clearances (air space) to combustible materials are not
adhered to. It is of greatest importance that this fireplace and vent
system be installed only in accordance with these instructions.
No hearth required
E
Alcove
WARNING
Fire hazard is an extreme risk
Flue Clearances to Combustibles
Horizontal - Top
Horizontal - Side
Horizontal - Bottom
Vertical
IMPORTANT: If installing a television above
this appliance, the television must be either
fully recessed into the wall above the
fireplace and or have a mantle below the
television. If the television is left unprotected,
the extreme heat being
emitted fom this
appliance will result in damage to the
television. See clearance requirements for
both mantle (page 9) and or enclosing the
top of the appliance (Page 11 D dimensions).
Installed close
to ceiling.
Regency GF900L-1 Gas Fireplace
76mm
51mm
51mm
51mm
Advertisement
Table of Contents
