Fan Service - Regency Fireplace Products Greenfire GF900L Owners & Installation Manual

FAN SERVICE

PRIOR TO SERVICING THE FAN, ENSURE UNIT HAS COOLED TO
ROOM TEMPERATURE, ALL POWER IS DISCONNECTED AND GAS
SUPPLY IS TURNED OFF.
1. Remove faceplate, inner frame, glass door, front trim piece and inner
panels - see instructions in this manual.
2. Remove logs.
3. Remove burner side panels by lifting out as shown in Diagram 1.
Diagram 1 - Burner Side Panels
4. Remove burner by removing 2 screws in locations shown below.
Diagram 2 - Burner Screw Locations
5. Remove rear log tray by removing 3 screws as shown in Diagram 3
below.
Diagram 3 - Log Tray screws
Regency GF900L-1 Gas Fireplace
6. Remove access panel by removing eight(8) screws in locations
shown in Diagram 4.
Diagram 4 - Access Tray screws
7. Loosen three (3) screws to remove heat deflector shown in Diagram
5.
Diagram 5 - Heat Deflector Screws
8. Remove two (2) screws to remove fan shown in Diagram 6.
Diagram 6 - Fan Screws
9. Reverse steps to reinstall fan.
maintenance
45