Commissioning Of The Cp9Xx Device; Comtraxx® User Interface Of The Cp9Xx - Bender COMTRAXX CP9 Series Manual

4.4

Commissioning of the CP9xx device

1. Switch on the supply voltage:
After switching on, the device performs a start routine. It is completed when the commission-
ing page appears n the display.
2. Enter the desired IP address in the 1
3. Enter the subnet mask in the 2
4. Enter the address of the default gateway.
5. Press the "Save" button to store the entries.
6. Wait 8...10 seconds. The COMTRAXX® system overview starts.
7. If there is a DHCP server in the network, select only the check box to the right of the "DHCP?"
label in line 4. Confirm your selection by pressing the "Save" button. The network settings
transmitted from the server are shown on the display after 8...10 seconds.
4.5 COMTRAXX® user interface of the CP9xx
The device has a web user interface for setting and operation.
How to start the web interface:
– Open an Internet browser from any network device.
– Enter the address of the CP9xx device into the address line of the browser.
It is possible to connect the CP9xx directly to a computer/laptop. In this case, the CP9xx can be con-
trolled with a second fixed IP address.
– Open the browser on the connected device
– Enter the following IP address: 169.254.0.1
CP9xx_D00349_08_M_XXEN/02.2022
Fig. 4.5: Commissioning page CP9xx device
nd
line
After this, the commissioning must be continued via the COMTRAXX
face.
st
line
®
user inter-
23