Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
D
Check the printed adjustment pattern.
When Manual(Standard) is selected
Two groups of adjustment patterns, A and B, are
printed. Select the pattern with the least amount
of overlapping or gaps for each group. Select
"-0.2%" in the cases shown below.
If there are patterns where the overlapping or
gaps are the same, enter the middle value in Step
5.
Enter "-0.15%" in the cases shown below.
If all of the adjustment patterns contain overlaps
or gaps, and you cannot narrow it down to 1,
select the pattern with the least overlaps and gaps.
Do Steps 2 to 5 again, and repeat them until a
pattern with no overlaps or gaps is printed.
If the pattern is difficult to check, such as if the
ink bleeds, input "0.0%" one time.
In this situation, the media feed is not adjusted.
Do the following steps to complete
Manual(Standard), and then perform
Manual(Measurement) again.
User's Guide
Basic Operations
E
96
When Manual(Measurement) is selected
Measure the space between patterns using a scale
of up to 0.5 mm (0.02 in.).
The screen for entering confirmation results for
the adjustment pattern is displayed.
When Manual(Standard) is selected
Set the values printed under the patterns selected
in A and B, and then press OK.
When Manual(Measurement) is selected
Set the value measured in Step 4, and then press
OK.
When adjustments are complete, the Home
screen is displayed.
Advertisement
Table of Contents
