Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
E
Use the hex wrench to loosen the head of the
screw so it rises up about 5 mm (1.96 in.) as
shown in the illustration.
F
Pull the screw out upward together with the
rubber part around it.
G
Pull the media holder toward the outer side.
User's Guide
Maintenance
H
I
J
130
Insert the new media holder from the outer side.
Insert the parts you pulled out in Step 6.
Use the hex wrench to tighten the screw until its
head is flush.
Advertisement
Table of Contents
