Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
U
Close the front cover, and then move the left and
right lock levers inward.
V
Set the media information on the screen, and
press OK.
Do the following settings here.
❏ Media: Set the media to use for printing
❏ Roll Winding Direction: How to wind the
loaded media
❏ Media Length: Length of the loaded media
❏ Media Detection: How to detect the width of
the media
When you select Media Settings while no Media
Type is set in Media, the screen to select Media
Type appears. Select the Media Type using the
paper weight of the loaded media as a guideline as
shown below. The paper weights of each Media
Type shown in the screen are typical values.
Media Type
Ultra-Thin
Thin
Med-Thick
Thick
In Media Detection, set Width Detection.
Normally, leave this On.
See the following for details about Media
Detection.
"General Settings menu" on page 152
U
Press OK, to start operations, such as detecting
the loaded media.
W
Follow the on-screen instructions to forward the
edge of the media to the given position as
necessary.
User's Guide
Basic Operations
2
Paperweight (g/m
)
39 or under
40 to 56
57 to 89
90 or over
76
Advertisement
Table of Contents
