Print Adjustments; Automatic Adjustment; Print Head Alignment - Epson SC-F10030H User Manual

SC-F10000H Series/SC-F10000 Series
Head Cleaning U "Print Head Cleaning" on
page 138

Print Adjustments

Use this menu in the following cases.
Using new media not registered to the printer
Perform Automatic Adjustment after loading media to
the printer.
When banding or graininess is found in the print
results even after Automatic Adjustment is
performed
Perform Print Head Alignment and Media Feed
Adjustment manually.
When changing Advanced Settings after saving
media settings

Automatic Adjustment

Print head position and media feed are adjusted while
printing the pattern.
The approximate maximum length of the media
required to print the test pattern is given below.
Approx. 600 mm (23.62 in.)
A
Check that the printer is ready, and load the
media according to the actual usage conditions.
When using the Auto Take-up Reel Unit, attach
the media to the roll core.
"Loading media" on page 70
U
"Using the Auto Take-up Reel Unit" on
U
page 77
B
Press , and then press in the order of Media
Settings - Print Adjustments - Automatic
Adjustment.
C
Press Start.
Auto adjust starts, and an adjustment pattern is
printed. Wait until adjustment is complete.
User's Guide
Basic Operations

Print Head Alignment

Auto
The same adjustment as Print Head Alignment of
Automatic Adjustment is performed.
The approximate maximum length of the media
required to print the test pattern is given below.
Approx. 300 mm (11.81 in.)
A
B
C
Manual
You can select Manual(Simple) or Manual(Standard)
to make adjustments.
Manual(Simple)
Select this when Auto adjustment has failed or when you
want to perform quick and simple adjustment by
visually inspecting the pattern.
Manual(Standard)
Select this when you want to perform adjustment
equivalent to Auto adjustment by visually inspecting the
pattern.
The approximate maximum length of the media
required to print the test pattern is given below.
Manual(Simple): Approx. 50 mm (1.96 in.)
Manual(Standard): Approx. 150 mm (5.9 in.)
93
Check that the printer is ready, and load the
media according to the actual usage conditions.
When using the Auto Take-up Reel Unit, attach
the media to the roll core.
"Loading media" on page 70
U
"Using the Auto Take-up Reel Unit" on
U
page 77
Press , and then press in the order of Media
Settings - Print Adjustments - Print Head
Alignment - Auto.
Press Start.
Auto adjust starts, and an adjustment pattern is
printed. Wait until adjustment is complete.