Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
❏ If the width is equal to or greater than 62 inches
but less than 76 inches, up to 4 patterns can be
printed in line (one on the Right, one in the
Center Right, one in the Center Left, and one
on the Left).
❏ If the width is equal to or greater than 47 inches
but less than 62 inches, up to 3 patterns can be
printed in line (one on the Right, one in the
Center Right, and one on the Center Left).
❏ If the width is equal to or greater than 32 inches
but less than 47 inches, up to 2 patterns can be
printed in line (one on the Right and one in the
Center Right).
❏ If the width is less than 32 inches or Width
Detection is set to Off, printing in line cannot
be done.
When Saving Mode is On
SC-F10000H Series:
❏ If the width is equal to or greater than 75 inches
but less than 76 inches, up to 2 patterns can be
printed in line (one on the Right and one in the
Center Right).
❏ If the width is less than 75 inches or Width
Detection is set to Off, printing in line cannot
be done.
SC-F10000 Series:
❏ If the width is equal to or greater than 53 inches
but less than 76 inches, up to 2 patterns can be
printed in line (one on the Right and one in the
Center Right).
❏ If the width is less than 53 inches or Width
Detection is set to Off, printing in line cannot
be done.
Press Start to print a nozzle pattern.
C
Cut the media as necessary, and then check the
printed patterns.
Example of clean nozzles
If no parts of the check pattern are missing, press
OK. The Maintenance screen returns.
User's Guide
Maintenance
Print Head Cleaning
Types of Cleaning
Print Head Cleaning is split between the following 3
types.
Perform head cleaning as necessary.
Perform head cleaning if there are faint or missing parts
of the check pattern that was printed.
You can perform head cleaning while printing by
pausing the job. However, printing may be disturbed
when printing is resumed.
See the following for details.
"Cleaning procedure" on page 139
U
Set Periodic Cleaning.
In Maintenance Setting, set Periodic Cleaning to On to
do periodic head cleaning as a preventative measure
before clogs actually occur in the nozzles. Set one of
Print Duration, Print Page, or Print Length for the
interval.
"Maintenance menu" on page 167
U
138
Example of clogged nozzles
If parts of the check pattern are missing, press
NG, and then do Print Head Cleaning.
"Print Head Cleaning" on page 138
U
c
Important:
Always remove clogs from the nozzles of all
colors before resuming use. If clogged nozzles
(including clogged nozzles for colors that are
not used) remain when printing after
resuming use, the clogs can no longer be
removed.
Advertisement
Table of Contents
