Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
E
Media holder
Place media on these holders. The same parts are on both the left and the right sides.
F
Roll support
Rest media on these supports before placing it on the media holders. The same parts are on both the left and the right
sides.
G
Lift lever
If the media to be mounted on the media holders seems heavy, use these levers to raise the media easily to the level of
the media holders. The same parts are on both the left and the right sides.
H
Handle
After placing media on the right media holder, rotate the handle and press the media holder into the roll core.
I
Media cleaner
Wipes off any lint or dust on the media when the media is being fed. If a message appears on the control panel's
screen, use the supplied media cleaner brush for cleaning.
"Cleaning the media cleaners" on page 111
U
J
Media cleaner brush
Dusts off the dirt on the surface of the media cleaner.
Since the brush's surface has a direction in which to wipe, move it in the direction that wipes off the dirt. You can
switch the direction in which to wipe. If you are not using the media cleaner brush, store it by hanging it on the hooks
on the back of the printer.
K
Presser roller spacer
This part fixes the pressure rollers in the open position. Pressure rollers that have spacers inserted do not apply
pressure to the media, even when the media loading lever is lowered. If you use the presser roller spacer when
wrinkles occur on the media end, the wrinkles may be improved.
If you are not using the presser roller spacer, store it by inserting it into its original place.
"How to use pressure roller spacers" on page 195
U
L
LAN port
Connects the LAN cable. Use a shielded twisted pair cable (category 5e or higher).
M
Data lamp
The data lamp lights or flashes to indicate the network connection status and whether the printer is receiving data.
On
: Connected.
Flashing : Connected. Receiving data.
User's Guide
Introduction
19
Advertisement
Table of Contents
