Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
Basic Operations
Workflow for Optimal
Printing
The following conditions must be fulfilled to print
optimally on the printer.
❏ The media settings values appropriate for the media
you are using are registered to the printer, and the
print information is registered to the RIP.
❏ The media is loaded appropriately on the printer.
❏ The print adjustments (print head alignment and
media feed adjustment) are executed using the
media to be used.
❏ The printer is kept in a proper condition.
Follow the steps below to fulfill the conditions.
1. Register media settings values. (when using
the EMX file with the new media)
You can easily register media settings values to the printer
using Epson Edge Dashboard. If you are registering with
Epson Edge Dashboard, download the EMX file
corresponding to the media that you are using in advance,
and have it registered to the printer.
"Using Epson Edge Dashboard" on page 39
U
2. Load the media.
Loads media to be used on the printer. The loading method
varies depending on the characteristics of the media.
If you are not using the EMX file, the optimal media settings
values will be registered just by selecting the Media Type
when loading the media.
"Loading media" on page 70
U
User's Guide
Basic Operations
3. Attach media to the Auto Take-up Reel Unit.
Attach the Auto Take-up Reel Unit to the edge of the media,
and make sure that automatic take-up can be performed.
The method of attachment varies depending on the
characteristics of the media.
U
4. Execute the Print Adjustments. (when using
new media)
Execute the Print Adjustments to optimize the media
settings values to the condition of the machine.
Usually, this is adjusted automatically by executing
Automatic Adjustment.
U
5. Check the condition of the printer.
Upon starting printing work, inspect the remaining ink
level and the condition of the print head nozzle.
U
6. Print.
Start printing from the Epson Edge Print.
U
Precautions When
Handling Media
If the following points are not observed when handling
media, small amounts of dust and lint may stick to the
media surface and cause ink drops in the print results or
cause the nozzles to clog.
Do not place exposed media directly on the floor.
Media should be rewound and inserted in its original
packaging for storage.
68
"Using the Auto Take-up Reel Unit" on page 77
"Print Adjustments" on page 93
"Before Printing" on page 92
"Using Epson Edge Print" on page 49
Advertisement
Table of Contents
