Table of Contents
Advertisement
SC-F10000H Series/SC-F10000 Series
❏
Ink is expended. Replace the old ink cartridge with a new one.
❏
More than 30 minutes has elapsed since the ink cartridge connector was disconnected. Immediately
connect the connector, if it is left the way it is, the ink will dry out and the printer may not function
normally.
It is time to shake the ink cartridges. Remove the ink cartridges and shake them.
An ink cartridge's connector is disconnected. Insert the ink cartridge and connect the connector
correctly.
Confirm that all of the cartridge covers are upright, and then follow the on-screen instructions.
Waste Ink Bottle status
Displays the approximate amount of space available in the Waste Ink Bottle. If the amount of space
decreases, the bar becomes shorter.
The display changes, as shown below, if a warning occurs.
The Waste Ink Bottle is almost full. Ready a new Waste Ink Bottle.
Wiper Roll status
Displays the guideline for replacement of the wiper roll. As the time for replacement gets closer, the bar
becomes shorter.
The display changes, as shown below, if a warning occurs.
The wiper roll will need to be replaced soon. A new wiper roll needs to be prepared.
Pressing the display area shows the Supply Status screen and you can check the part numbers for consumables. You
can also switch the ink cartridges to be used. (Changing the active slot)
To change the ink cartridge, press the bar display of the one you are not using, confirm the on-screen message, and
then press Start.
E
Footer
Displays the current date and time and the temperature and humidity around the printer. If the temperature and
humidity are out of range for the printer's operating environment,
printer within the range of the printer's operating environment. The footer also appears similarly on other screens.
F
Dryer information
User's Guide
Introduction
26
appears. For high-quality printing, use the
Advertisement
Table of Contents
