Serial Device Connection; Usb Device Connection; Figure 3-7: Db-9 Serial Port Connector - IEI Technology AFL3-W07A-BT-N1/PC/2G-R20 User Manual
Flat bezel panel pc with intel celeron n2807 dual-core cpu, touchscreen, dual usb 3.2 gen 1, dual gbe lan, dual rs-232, hd audio, wi-fi 802.11a/b/g/n/ac and rohs
Table of Contents
Advertisement
3.6.2 Serial Device Connection
Follow the steps below to connect a serial device to the DB-9 connector of the
AFL3-W07A-BT panel PC.
Step 1:
Locate the DB-9 connector. The location of the DB-9 connectors is shown in
Chapter 1.
Step 2:
Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the bottom panel. See Figure 3-7.
Figure 3-7: DB-9 Serial Port Connector
Step 3:
Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
3.6.3 USB Device Connection
NOTE:
User must install the USB 3.0 driver before connecting a USB device to
the system or else the system may not recognize the connected
device.
Page 20
AFL3-W07A-BT Panel PC
Advertisement
Chapters
Table of Contents
