Explanation Of Terms; Safety Notices - Hanseatic WQP8-7636Q User Manual

Page EN-6 Safety
Safety
Intended use
The dishwasher is exclusively intended for
washing dishes in ordinary quantities for pri-
vate households and is not suitable for com-
mercial use or multiple use (e.g.: use by sev-
eral families in an apartment building).
Only use the dishwasher as described in this
user manual. Any other use is deemed im-
proper and may result in damage to property
or even personal injury. The manufacturer
accepts no liability for damage caused by im-
proper use.

Explanation of terms

The following symbols can be found in this
user manual.
WARNING!
This symbol indicates a hazard with a medi-
um level of risk which, if not avoided, could
result in death or serious injury.
CAUTION!
This symbol indicates a hazard with a low lev-
el of risk which, if not avoided, could result in
minor or moderate injury.
NOTICE
This symbol warns against possible damage
to property.
This symbol refers to useful additional
information.

Safety notices

In this chapter you will find general
safety notices which you must always
observe for your own protection and that of
third parties. Please also pay attention to the
warnings in individual chapters on installation
and operation, etc.
WARNING!
Risks in handling household
electrical appliances
Risk of electric shock!
Touching live parts may result in severe in-
jury or death.
Only use the appliance indoors. Do not
■
use in wet rooms or in the rain.
Do not operate or continue to operate the
■
appliance if
– it shows visible signs of damage, e.g. the
power cord is defective.
– it starts smoking or there is a smell of
burning.
– it makes unfamiliar noises.
In these cases, you should pull the mains
■
plug out of the socket or switch off /un-
screw the fuse and have the appliance re-
paired (see „Service" on page EN-32).
The appliance corresponds to protection
■
class I and may only be connected to a
plug with a protective conductor that has
been installed properly. When connect-
ing, make sure that the voltage is correct.
You can fi nd more detailed information
about this on the nameplate.
If the mains plug is no longer accessible
■
after installation, an all-pole disconnect-
ing device complying with overvoltage
category III must be connected into the
house wiring with a contact gap of at least
3 mm; this includes fuses, circuit breakers
and covers.
We recommend using a pulse-sensitive
■
residual-current device (RCD).
Do not operate the appliance with an ex-
■
ternal timer or a separate remote control
system.
Keep the appliance, the mains plug and
■
the mains cord away from open fl ames
and hot surfaces.
Do not kink or pinch the mains cord or lay
■
it over sharp edges.
If the mains cable of the appliance is dam-
■
aged, it must be replaced by the manu-
facturer, the customer service department