Table of Contents
Advertisement
Available languages
Available languages
Operation
(1)
(2)
(3)
(4)
(5)
(11)
(12)
(13)
Preparation
Requirements:
– You have read chapter „Safety" from page
EN-6 and understand all the safety notices.
– The appliance is set up and connected as
described in chapter „Installation, connec-
tion and initial commissioning" from page
EN-23.
– Dishwasher detergent, rinse aid and dish-
washer salt and multitabs are added.
1. Open the tap completely.
2. Close the dishwasher door.
3. Press the
button (1) to switch on the
dishwasher.
You will hear a signal tone and all LEDs
will illuminate briefly.
After a short while, the display will show
"P3" (indicating programme 3 "ECO" (13)).
(6)
(14)
(15)
(16)
(17) (18)
Operation
(7)
(19)
(23)
(22)
Signal tones
The appliance sounds a signal tone when
buttons are pressed. This tells you that the
appliance has understood your action.
A signal tone also sounds at the end of the
programme run.
If you open the door while the programme
is on, a signal tone reminds you to close the
door again and continue the programme.
Display
The display informs you of the current status
before, during and after the programme run.
Page EN-17
(8)
(9)
(10)
(20)
(21)
Advertisement
Chapters
Table of Contents
