Having The Outlet Hose Connected - Hanseatic WQP8-7636Q User Manual

Page EN-24 Installation, connection and initial commissioning
Substructure
90°
82 cm
58 cm
Inlet/outlet area and
electrical connec-
tion.
45 cm
Recess dimensions
• If you want to assemble your dishwasher
under a worktop, please make sure that
the worktop is continuous and that it is
screwed to the cupboards next to the
dishwasher.
• If you would like to install the dishwash-
er in a corner unit, ensure that there is
enough space in the corner to easily open
the door.
1. Turn the two screws on the back of the
cover plate.
2. Pull the cover plate backwards and re-
move it.
3. Fasten the two screws on the rear of the
dishwasher again.
90°
80 mm
4. Affix the enclosed moisture barrier
tape (c) to the underside of the worktop.
In this way, you will avoid damage to the
work surface as a result of hot steam
100 mm
which may be emitted from the dishwash-
er if the dishwasher door is left open.
5. Position the dishwasher in the niche as
described earlier.
Having the outlet hose
connected
Malfunction!
Failing to connect the appliance cor-
rectly may cause malfunctions during
operation.
Make sure that the waste water can
■
drain freely at any time. To that end,
the outlet pipe must have a minimum
diameter of 40 mm.
Ensure that there are no kinks or dam-
■
age to the outlet hose.
Make sure that the end of the hose is
■
not submerged in the pumped water.
Do not extend the outlet hose or re-
■
place with another drainage pipe.
(c)
NOTICE