Explanation Of Terms, Explanation Of Symbols, Definitions; Explanation Of Terms; Explanation Of Symbols; Definitions - Hanseatic HGU6082B14U7735ES User Manual

Table of Contents

Advertisement

Available languages

Available languages

Explanation of terms, explanation of symbols, definitions

Explanation of terms, explanation of symbols, definitions
Please read through the safety
notices and the user manual
carefully before using the appli-
ance. This is the only way you can use all
the functions safely and reliably.
Be sure to also observe the national reg-
ulations in your country, which are valid in
addition to the regulations specified in this
user manual.
Keep all safety notices and instructions
for future reference. Pass all safety notic-
es and instructions on to the subsequent
user of the product.

Explanation of terms

The following signal terms can be found in
this user manual.
WARNING
This signal term indicates a hazard with a me-
dium level of risk which, if not avoided, could
result in death or serious injury.
CAUTION
This signal term indicates a hazard with a low
level of risk which, if not avoided, could result
in minor or moderate injury.
NOTICE
This signal term warns against possible dam-
age to property.
You will find information in chap-
ter "Installation, connection and
initial
commissioning"
page EN-31.

Explanation of symbols

The following symbols can be found in this
user manual:
This symbol refers to useful addi-
tional information.

Definitions

"Place setting" means a set of tableware in-
tended for use by one person, excluding serv-
ing dishes.
"Operating cycle" means a complete clean-
ing, rinsing and drying cycle, depending on
the selected programme, covering a series of
operations until the end of all activities.
"Programme duration" means the period from
the start of the selected programme, without
any preset time programmed by the user, until
the notification of the end of the programme,
from which point the user has access to the
tableware.
"Preset time" means a state in which the user
has postponed the start of the operating cy-
cle of the selected programme for a certain
period of time.
from
Page EN-3

Advertisement

Chapters

Table of Contents
loading

Table of Contents