Microcom 438 Operator's Manual page 32

Chapter 3
manual for more information regarding the correct value for the Dot2Gap. The value
entered is in dots or pixels.
3.3.11.2.8 Feed Options - SPG
The Steps Past Gap (SPG) is a format header parameter that the printer uses to register the
page properly. If the Auto SPG is checked, the driver will automatically calculate the proper
SPG based on the other entered fields. If unchecked, the SPG is entered in manually. This
value is entered in as dots.
3.3.11.2.9 Feed Options - Activate Gap Detection (dots)
The Activate Gap Detection is the distance in dots that the printer will move media before
trying to detect a registration mark. The default of 1 typically works for most media types. If
the media being used contains preprint in the sensor area, the AGD may need to be used to
disable registration detection until passing over the preprinted areas.
3.3.12 Printing Preferences - Presenter tab
The Presenter tab controls the operation of the optional presenter available on some printer
models. A presenter is a post printing device that typically takes a printed and cut form and
presents it to the user only after is has printed completely. Not every printer model is
capable of running a presenter. Check with your printer model operator's manual to see if a
presenter is supported. This tab is ignored on models that do not support the use of a
presenter.
438 Operator's Manual - 880052-0103
Getting Started
3-15