Microcom 438 Operator's Manual page 216

16 400
17 425
18 450
19 475
20 500
21 525
22 550
23 575
24 600
25 625
^A ^D COMMAND
X 158 Set the Transmissive Dot2Gap Value: This is the distance of the
transmissive sensor, that detects diecut and blow hole registration marks, to
the dot row.
468 203dpi 438
730 300dpi 438
X 159 Brownout Reporting: Reports the number of recorded brownout conditions.
0 After a power up, reports the "running" total of detected Brownouts.
1 Clears the "running" total or volatile brownout count
5 Reports the non-volatile brownout count stored in memory
255 Clears the non-volatile brownout count stored in memory
X 162 Set Advance/Retract Speed: This command is used to set the
advance/retract speed of the dispense commands (^D97, ^D98, ^D99, ^D111)
and uses the same speed table as the ^D46 command.
163 Read Current Sensor Status: This command is used to report the current
status of the printer's sensors. This is useful in setup and/or troubleshooting.
164 Generate Data Matrix Barcode
X 165 Set the Reflective Dot2Gap Value: This is the distance of the reflective
sensor, that detects blackline registration marks, to the dot row.
468 203dpi 438
730 300dpi 438
166 Generate 4-State Intelligent Mail Barcode
X 176 Generate Planet Code Barcode
438 Operator's Manual - 880052-0103 13-19