Table of Contents
Advertisement
4-2
POLE INSTALLATION METHOD
1
body.
Cover
Sensor body
Installation plate
2
Countersunk oval-head screw
About the grommet
for the sensor exterior.
through the recess.
Back to back pole installation
plates.
4
locations
4
locations
Note: This device can be attached to a pole with diameters of 1.65" (Ø42 mm) to 1.95"
Cover fixing screws
Sensor fixing screws
(M4x20)
Note: Accessories
Pole
installation
fitting
dotted lines in the drawing below using nippers
Installation to a pole
exceeding Ø1.95" (Ø49 mm)
then tap an M4 hole.
drilling a pilot hole on the pole.
plate using screws.
M4 tap
Note: Accessories
(Ø49 mm).
3
wiring.
body to the installation plate.
About the cut bush
Grommet
Refer to section 5 INITIAL SETTING to the functions setting.
4
Refer to section 6 WIRING METHOD to connect the wiring.
Refer to section 7 OPTICAL AXIS ADJUSTMENT
to adjust the optical axis.
5
tools as and when needed.
Pole cover for PXB
(Optional accessory)
Knockout
For Ø1.68"
Countersunk
(Ø42.7 mm)
oval-head
For Ø19.1"
screw
(Ø48.6 mm) (single tube)
(M4x20)
Diameter supported by pole
10
.
Note: If there is a gap between the wire
included to tighten and close the gap.
Knockout
Note: Cut the upper section only if the pole
penetrates the top surface.
Bird stopper
(Accessory)
Knockout
Advertisement
Table of Contents
