Advertisement
・Reflector
Assembly
Self tapping screw
Insert reflectors
parallel to the
reflector holder
When reflector
is detached
POLE MOUNT
※Use outside dia. 1.50" (38mm) to 1.77" (45mm) pole.
①Insert 2pcs. of oval countersunk head screws (M4×20)
into the pole bracket with a few turns.
②Fix pole mounting plate to pole with the pole bracket.
③Fix sensor mounting plate or re ector mounting plate on
the pole mounting plate with 2pcs of M4×6 screws
attached to it.
SENSOR
Sensor mounting plate
Detach cover, and
Pole mounting
remove mounting plate
plate
from sensor body.
Follow the same procedure as ③ to ⑤ of wall mount.
●
REFLECTOR
reflector unit
pole mounting
plate
Follow the same procedure as wall mount.
●
0.79"
(20mm)
5.91"
(150mm)
Holes
Center of reflector
Wall
Pole bracket
Pole bracket
①Insert self tapping screws into the wall by about 0.79"
(20mm) and hang the re ector unit back plate on them
using the holes.
Set the center of the re ector unit and minddle point of
the sensor lenses at the same height, and you will nd
it easier to adjust alignment.
The re ector unit should be installed uprightly and
vertically.
Make sure that the re ector's front side faces the
sensor.
②Tighten the screws until the re ector unit is
rmly.
③Fix 3 re ectors to the re ector unit rmly.
※For indoor use, hood is not necessary.
BACK TO BACK POLE MOUNT AND
RIGHT ANGLE POLE MOUNT
①First, x the pole mounting plate for the 1st unit.
②Let the 2nd unit pole bracket run under the 1st unit
pole mounting bracket and x the 2nd pole mounting
plate up side down.
・Follow the same procedure as ③ to ⑤ of wall mount.
・Not applicable for the re ector.
xed
Advertisement
