Table of Contents
Advertisement
5
INITIAL SETTING
5-1
MODULATION FREQUENCY CHANGEOVER
* Set the transmitter and the receiver to the same channel.
Factory set : 1CH
1 2
5-2
SYNCHRONIZED TIMING
In order to avoid cross talk between the same channel, select the different timing setting A or B.
Factory set : A
3
5-3
MASTER/SLAVE SELECTION
Master : Output the synchronized signal from synchronized output terminal.
Slave : Transmitter irradiate a beam as setting channel and setting timing according to synchronized input signal from master.
Factory set : Master
4
5-4
BEAM POWER SELECTION
Select the suitable power according to the installation site (Detection Distance)
Factory set : H
5
L
250ft (75m) or less 250ft (75m) - 330ft (100m)
5-5
ALARM OUTPUT SWITCH
* Select N.O. or N.C.
5-6
ENVIRONMENTAL OUTPUT SWITCH
* Select N.O. or N.C.
1 CH
2 CH
3 CH
1 2
1 2
1 2
* Installed on the transmitter and the receiver
* Set the same timing for same transmitter, receiver pair.
A
B
* In case add one more set in same synchronized wire group,
Please set the different timing.
3
3
* Only installed on the transmitter (Receiver to be slave only)
Master Slave
* Select only one transmitter as Master and others as Slave
* One master for up to 7 slaves (Transmitter : 3, Receiver : 4) in one synchronized
wire group.
4
4
* Only installed on the transmitter
L
H
5
5
H
* Only installed on the receiver
* Only installed on the receiver
* Installed on the transmitter and the receiver
* In case of 2 level installation, set the same channel
4 CH
and change the synchronized timing.
* In case of more than 3 level installtion, change the
1 2
channel but not neighboring number.
300ft (90m)=H
300ft (90m)
200ft (60m)=L
200ft (60m)
Factory set : N.C.
N.C.
4
4
Factory set : N.C.
N.C.
5
5
11
N.O.
4
N.O.
5
Advertisement
Table of Contents
